Choose The Doorbell You Are Working With


VIDEO DOORBELL	WIRELESS VIDEO DOORBELL

Video Doorbell

Included in this section:

Specifications

Specifications

View full installation guide here.

Minimum wire gauge should be 20 gauge. Cat5e wire not supported for power.
From the Alarm.com Mobile App, tap the hamburger menu (3 stacked lines) in the upper left hand corner.
Choose "Add Devices"
Choose "Video Camera"
Choose "ADC-VDB770" and follow the prompts

View compatible chime guide here.

Off	Power off
Solid Red	No local or Internet connection
Blinking Red	Power on, camera booting
Solid Green	Connected to Alarm.com
Blinking Green	Local network connection
Double-Blinking Blue	Unable to ring indoor chime
Solid Yellow	Cool-Down mode is active
Blinking Blue	WPS mode (press and hold button for 30-35s)
Blinking White	Wi-Fi Access point mode (press and hold button for 35-40s)
Blinking Yellow	Camera power cycling (press and hold button for 40-45s)
Alternating Red and Green	Camera resetting to factory default (press and hold button for 45-50s)

View our Video Troubleshooting Guide if you are having trouble viewing your camera.

Included in this section:

Specifications

View full installation guide here.

View full installation guide here.

Button Light Guide

Operational States

Mode	Description	Button LED Color
Standby or Off	The camera is in standby mode (normal operation) or the battery is drained and requires charging	Off
Local Connection	The camera has a local network connection	Solid Green
No Local Connection	The camera does not have a local network connection	Solid Red
Low Battery	The camera's battery is low and requires a recharge	Alternating Red and Blue
Connecting to Network	The camera is powered on and connecting to a network	Blinking Red
WPS Mode	The camera is in WPS mode. To enter this mode, press and hold the button for 30-45 seconds	Blinking Blue
AP Mode	The camera is in AP pairing mode. To enter this mode, press and hold the button for 30-45 seconds	Blinking White
Power Cycle	The camera is being power cycled. To enter this mode, press and hold the button for 46-60 seconds	Blinking Yellow
Factory Reset	The camera is resetting to factory default settings. To enter this mode, press and hold the button for 61-75 seconds	Alternating Red and Green
Firmware Upgrade	The camera's firmware is being updated	Blinking Yellow Rapidly

Charging States

Mode	Description	Top LED Behavior	Button LED Behavior
Charging	The battery pack is plugged in and charging	Solid Orange	On Button Press Solid Green = >75% charged Solid Orange = 15%-75% charged Alternating Red and Blue = <15% charged
Fully Charged	The battery pack is fully charged	Solid Green	On Button Press Solid Green
Failure Charging	The battery pack stopped charging because the device was plugged in too long. Remove the charging cable and re-attempt charging after one hour. If you see the same behavior, please contact support.	Alternating Orange and Green	Alternating Red and White
Operational Temperature Range for Charging Exceeded	The battery pack's internal temperature is either too hot or too cold. Please charge the battery pack in a room temperature environment.	Solid Green or Solid Orange	Alternating Red and Yellow

View our Video Troubleshooting Guide if you are having trouble viewing your camera.